CDI Immobiliser Bypass: Gilera Runner ST200 ST 200 Aprilia RX125 This set of taper roller

This set of taper roller bearings is designed to replace the original set of steering stem bearings on an R 100 CS for the years shown above

The mounting points or hole centres are 55-60mm apart and there is one spade connector with 1 lead and cap

1982 & 1983

If you're having spark issues with your LTF 300 then it's a no brainer to get a new coil on the quad as they're the usual culprit of a poor spark

This means they save money over time

CDI Immobiliser Bypass: Gilera Runner ST200 ST 200 Aprilia RX125 This set of taper rollerBrand New CDI Immobiliser Chip Key Bypass unit to fit: Gilera Runner ST 200. To replace Magneti Marelli CDI units stamped ACI600 ACI601 ACI602 ACI603 ACI604 units or EFI Technology units stamped AC2i AC3i AC5i AC8i. Please note other CDI Immobilisers may look similar but the original CDI must have one of the AC numbers mentioned above stamped on it for this to fit. Simply plugs straight in to the existing wiring loom. No wires to cut, no soldering,